Installation of a pump
is critical to its smooth functioning and efficiency. If a pump is installed
with inappropriate piping arrangements, there are chances of premature pump
failures and other pump related problems. There are several points that you
need to consider during pump installation.
The most important ones are
explained below –
- Run the cable so that it does not
have any sharp bends and is not pitched.
- Connect
the hose with discharge flange using quick change coupling.
- Avoid too many creases in the hose
pipe or use minimum bend in G.I. Pipe.
- Use
good quality control panel containing ammeter, voltmeter with under load
protection, single phase preventer.
- Place
the pump on a plank which will prevent it from sinking into a soft bottom or
suspend it by a rope few inches above the bottom.
- Check
if impeller is rotating in correct direction
Darling Pumps offers a wide range of submersible pumps for a variety of applications including slurry pumping, dewatering, clear
water pumping, sewage disposal and more.
To know more about our products, visit
http://darlingpumps.in/. To discuss which pump is best suited for your application, call +91 99819 92838.
